Knox Keysecure 3b Installation Manual Hot __full__ Jun 2026

Replace any SFP module with an SFP+ (e.g., Finisar FTLX8571D3BCL). Use show interfaces transceiver to verify.

Proper installation requires following exact step-by-step mechanical and electrical layout specifications. Mechanical Installation Steps

Must be connected directly to a constant, unswitched 12V DC battery source. Do not connect to ignition-switched power. 📈 Step-by-Step Installation Instructions knox keysecure 3b installation manual hot

The installation wizard will guide you through the installation process. Follow these steps:

Insert the tech-key into the lock and turn it until loosened to remove the faceplate. : For vehicles , choose a solid structural surface. Replace any SFP module with an SFP+ (e

Connects to the vehicle's security or telemetry system to log when the unit is removed from its mount. Step 4: Secure the Unit Align the KeySecure 3B housing with the drilled holes.

Use the backplate as a template to mark mounting holes. Mechanical Installation Steps Must be connected directly to

Connect to the optional remote release trigger from dispatch or an external switch (requires a momentary ground or positive signal depending on programming).

Place a 3A inline fuse on the positive (Red) wire within 12 inches of the power source.

Connect a laptop with KnoxConnect software installed to the USB or proprietary data port on the side of the unit. Upload the facility or department master profile.

(Dependent on vehicle vs. wall mounting).