Wella Climazon Millenium Manual Install ❲95% HIGH-QUALITY❳

Press to verify the fans cool down and the side wings retract smoothly. 6. Maintenance and Troubleshooting

: Options include one-piece (BB04/1) or two-piece (BB04/2) floor mounts.

Federarm (spring arm), Ausleger (support arm), Bremsschrauben (brake screws), and cover caps. 2. Installation Steps

Start a brief 2-minute diagnostic program to confirm all five infrared heating zones activate uniformly. ⚠️ Safety Precautions wella climazon millenium manual install

Adjust the friction screws at the head articulation point. The head should tilt smoothly when pushed manually but must remain firmly in place once released. Step 4: Routing the Cables

Protect the temperature sensor's safety filter from dust buildup 1.2.5.

Before you physically mount the dryer, verify the following. Ignoring these steps is the #1 cause of warranty voidance and electrical failure. Press to verify the fans cool down and

If you encounter error codes on the LCD screen during initial setup, consult the specific error index in the back of your original paper user manual or contact an authorized Wella service technician. Do not attempt to open the sealed infrared heater housings yourself, as this voids the manufacturer warranty. To help you get your salon set up correctly, let me know:

Insert the casters into the base (ST5 type) and secure them.

Before unboxing the unit, verify that your salon space meets the necessary technical and structural requirements. Electrical Specifications ⚠️ Safety Precautions Adjust the friction screws at

Use a soft, damp cloth with mild detergent; never use flammable substances like gasoline or lacquer thinner.

Position the wall bracket so that the pivot point sits roughly 1.8 to 2.0 meters (5.9 to 6.5 feet) above the finished floor level. This ensures optimal clearance when the arm is extended over a styling chair.

Wall installation saves floor space but requires absolute structural stability. Failure to anchor correctly can cause the heavy articulated arm to tear out of the wall. Step 4.1: Position the Wall Bracket