By following this manual, you should be able to successfully install, configure, and operate your V2000-C RFID Access Control system. If you encounter issues not covered here, please consult your vendor or the original manufacturer's documentation.
To modify settings, you must enter Programming Mode. While in this mode, the indicator light changes color (typically flashing orange or red).
Swipe the RFID card past the reader interface. (The unit will beep to confirm enrollment). V2000-c Rfid Access Control User Manual
Check output voltage with a multimeter. Verify wiring polarity. Incorrect lock wiring Check if lock is wired to NO instead of NC (or vice-versa). Keypad beeps continuously Tamper switch activated Ensure backplate is securely fastened to the wall. Keypad rejects programming code Master Code changed Perform a factory hardware reset to restore default code.
(Invoking related search terms...)
Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings.
Connect the power supply to the V2000-C GND and the COM terminal. By following this manual, you should be able
The system is a versatile, standalone security solution designed for small to medium-sized businesses, residential complexes, and secure storage areas. This manual provides a step-by-step guide on how to install, wire, and program your device to ensure maximum security. 1. Technical Specifications
Connect the positive wire of the lock to NC , the negative wire of the lock to GND , and bridge COM to +12V . When power is lost, the lock opens. While in this mode, the indicator light changes
Connect the wire to the GND output of the power supply.
If you cannot enter programming mode, you must reset the device to factory defaults. Power off the unit, press and hold the exit button, power on, and wait for the beeps.