Qyt Kt8900 Programming Cable Pinout Top __full__ Official

What programming cable works with QYT KT 8900 ... - Facebook

: If you hand-soldered the connection, ensure TXD maps to the Tip and RXD maps to Ring 1. Reversing these lines is the most common cause of communication timeouts.

You have a mirrored pinout. Flipping the plug swaps pins 1 and 8. That means your cable is wired opposite: Pin 8 is GND. This is non-standard; re-crimp properly. qyt kt8900 programming cable pinout top

QYT KT-8900 3.5mm TRRS (4-pole) TRS (3-pole) stereo jack for programming, typically located on the rear panel of the radio. While the physical port is a 3.5mm audio-style jack, it functions as a serial data interface. Programming Cable Pinout

What programming cable works with QYT KT 8900 ... - Facebook What programming cable works with QYT KT 8900

Open (Windows) to identify which COM Port has been assigned to your adapter (e.g., COM3). Turn OFF your QYT KT-8900 radio.

Solder a wire from the of the 3.5 mm plug to the GND pin on the USB-to-TTL board. You have a mirrored pinout

| Pin Number | Signal Name | Description | | --- | --- | --- | | 1 | TXD | Transmit Data | | 2 | RXD | Receive Data | | 3 | GND | Ground | | 4 | NC | No Connection | | 5 | NC | No Connection | | 6 | NC | No Connection | | 7 | RTS | Request to Send | | 8 | CTS | Clear to Send | | 9 | GND | Ground |

| Symptom | Likely Pinout Issue | Fix | |---------|--------------------|-----| | "Radio not found" | Pin 2/3 swapped, or GND missing | Swap TX/RX; check Pin 1 continuity | | Timeout after reading 1% | +5V on Pin 6 is missing | Bridge +5V from USB adapter (if ≤100mA) | | Garbage characters in terminal | Incorrect baud rate | Ensure 9600, 8N1, no flow control | | Radio resets when plugging cable | GND loop or 5V short | Add a 100Ω resistor on Pin 6 |

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Data input to the radio (Connects to USB-TTL Adapter TX ).