Lovato 31: Rgam 12 User Manual ((new))
Forces the generator to start to verify performance without necessarily switching the load. đź“‹ Measured Data & Monitoring
The Lovato RGAM series comprises modular rotary cam switches for manual control and switching of electrical circuits up to 12A, 690V AC. They are used for ON/OFF, changeover (two sources), star-delta, voltmeter/ammeter selection, and motor control applications. The specifically refers to the frame size with 12A thermal current.
To reset an alarm after the root cause has been resolved, simply press and hold the key. lovato 31 rgam 12 user manual
The controller is powered, but the generator is prevented from starting, and the ATS will not switch.
is a microprocessor-based engineered by LOVATO Electric Forces the generator to start to verify performance
This is the standard operational state. The internal microprocessor continuously samples the phase angle between the voltage and current vectors. It computes the active and reactive power components, automatically selecting the most efficient combination of capacitor steps to reach the target set in P.01 . Manual Mode
Meets standard IEC/EN 60255-6, EN 50081-1/2, and EN 50062-1/2. 2. Technical Specifications The specifically refers to the frame size with
Serial RS232 or RS485 interfaces for remote supervision and PC-based configuration.
The Lovato RGAM series are microprocessor-based control units designed for generator sets (gen-sets).
Ensure these match your local infrastructure.
Forces the generator to start to verify performance without necessarily switching the load. đź“‹ Measured Data & Monitoring
The Lovato RGAM series comprises modular rotary cam switches for manual control and switching of electrical circuits up to 12A, 690V AC. They are used for ON/OFF, changeover (two sources), star-delta, voltmeter/ammeter selection, and motor control applications. The specifically refers to the frame size with 12A thermal current.
To reset an alarm after the root cause has been resolved, simply press and hold the key.
The controller is powered, but the generator is prevented from starting, and the ATS will not switch.
is a microprocessor-based engineered by LOVATO Electric
This is the standard operational state. The internal microprocessor continuously samples the phase angle between the voltage and current vectors. It computes the active and reactive power components, automatically selecting the most efficient combination of capacitor steps to reach the target set in P.01 . Manual Mode
Meets standard IEC/EN 60255-6, EN 50081-1/2, and EN 50062-1/2. 2. Technical Specifications
Serial RS232 or RS485 interfaces for remote supervision and PC-based configuration.
The Lovato RGAM series are microprocessor-based control units designed for generator sets (gen-sets).
Ensure these match your local infrastructure.