Disco 240 Dmx Controller Manual Online

Scenes are the building blocks of your light show. A scene captures a specific layout of colors, positions, and gobos across your selected fixtures.

The controller sends DMX values as follows (Faders 1-16 = Channels 1-16 relative to fixture start address):

: For long cable runs, insert a DMX terminator into the "DMX Out" of the final fixture to prevent signal ghosting. 2. DMX Addressing (Channel Mapping) disco 240 dmx controller manual

The Speed fader controls how long a scene stays on screen before changing. The Cross (Fade) Time fader dictates how smoothly one lighting look transitions into the next.

Press and hold the Program button for roughly 3 seconds until the indicator LED flashes. Scenes are the building blocks of your light show

Always check this if your lights aren't responding. When active, it cuts all output signal. DMX Terminate: If your lights are flickering or acting "nervous," plug a DMX terminator into the last light in your chain to clean up the signal. Manual Override:

The controller screen and fixture lights will flash, confirming the scene is successfully saved. Press and hold the Program button for roughly

Disclaimer: This article provides a general overview of the Disco 240 DMX controller, which is sold under various brand names. Always refer to the specific manual provided by your product manufacturer for exact instructions. Ac turpis egestas - Beb Luna Federiciana Altamura

A chase is a sequence of scenes (up to 240 steps).

Adjusts how long a scene stays active before moving to the next one during Chase playback.