Connect the (Positive +) clamp to the positive terminal of the battery.
Snap the directly onto the positive battery terminal.
: When the needle stops dropping and stays at a low level (it may not reach zero), the battery is essentially full and should be disconnected. 3. Estimated Charging Time bradex bx60 battery charger instructions best
| Symptom | Likely Cause | Best Fix | | :--- | :--- | :--- | | Red light flashes forever | Battery is deeply dead (below 3V) | Try a "jump start" with another battery for 10 mins, then reconnect BX60. | | Green light instantly | Charger sees surface charge | Turn on headlights for 30 seconds (car off), then recharge. | | Unit clicks & flashes | Reverse polarity | Swap the clamps immediately. (Red to Pos, Black to Neg). |
Ensure battery terminals are clean and free of corrosion. Connect the (Positive +) clamp to the positive
When first connected, the needle will point to the right, indicating a high charging rate as it fills the battery.
Connect the clip to the negative battery terminal. | | Unit clicks & flashes | Reverse
: If the battery is completely flat, the charger may not recognize it. Some users find success by leaving it connected for several hours to "wake up" the cells.
is a reliable, budget-friendly 4A charger designed for all 12V lead-acid car batteries. Whether you're a DIY novice or just need a dependable backup in the garage, this guide will walk you through the safest and most effective way to get your battery back to life. Quick Setup Guide
Always connect the clips to the battery before plugging the charger into the wall.