Elias wiped grease from his forehead with the back of his hand, leaving a dark smear. He reached for the only item on the desk that was pristine: .
To set up a basic time-lapse, follow these steps on the transmitter:
Use the left and right arrow keys to navigate between .
To ensure reliable operation, the transmitter and receiver must share the same digital channel (01 to 99) or use the Smart Channel mode (00). aodelan wtr2 user manual
Sets a countdown timer before the first picture.
Before you begin, ensure your package contains the following components:
: Ensure both the transmitter and receiver are on the same channel to sync. Elias wiped grease from his forehead with the
To change the channel on the transmitter, press the arrows to highlight the channel icon ( CH ). Press SET . The digits will flash.
Slide the receiver into your camera’s hot shoe/cold shoe mount. Tighten the locking ring to secure it.
: Ensure the camera is set to the correct remote or drive mode as required by your specific camera model. To ensure reliable operation, the transmitter and receiver
(Note: AAA batteries for the transmitter and CR2 batteries for the receiver are typically purchased separately.) ⚙️ Device Layout and Interface
: Allows you to program a specific number of exposures (from 1 to 999 or infinite).
Press the button to execute the programmed sequence. 🛠️ Troubleshooting and Maintenance
Plug the shutter release cable into the receiver and the corresponding remote port on your camera body.